+1
The setup phases are confusing, can anyone explain where exactly they run?
The Pre script runs previously to insert the records in the valid table, it’s correct in my case, but the post script that must be run after the records inset, doesn’t run.
My script it’s:
Best answer by Christian Hauggaard
View original
+1
The script optimized it’s:
But it doesn’t works.
+5
In order to troubleshoot, can you please try to remove the pre-step, and just include the post-step? And check if this works?
In other words, try setting the following to <None> and then re-execute.
+5
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.
