As you can see in the screenshot, I think that this situation must be controled:





How did you actually manage to select a field in your selection rule, that is not available in your mapped (source) table?
Very interesting! I believe the Data Selection Rules panel should only list the columns that have a mapping to the source table. In my TX environment that is actually what I'm seeing.
I'll be following this.
Even worse, if you implement such a Data Selection Rule on an incremental table that has already been loaded to DSA from ODX (ADLS) it may work until you run an explicit full load.
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.