Skip to main content
Solved

Full load doesn't update the _I table?

  • October 1, 2020
  • 1 reply
  • 31 views

Hi!

Can you clearify that if I run a full load ( on a source based incremental table), it doesn't update the _I table with the current max value? 

In our scenario, I run a full load very early in the morning and then run incremental loads during the day. But I have seen that the first incremental load of the day takes a very long time to run which I suspect is due to there being a lot of changes since the last incremental load, i.e. the full load's transfer is ignored by the incremental load?

So the first incremental load, more or less, transfers the same data that the full load did?

Version 19.11.7.64

Regards

Niclas

Best answer by JTreadwell

Hi Niclas, a full load should be updating the _I table. The behavior you are describing is not expected and should be sorted out. Have you made any progress here? 

View original
Did this topic help you find an answer to your question?

1 reply

JTreadwell
Employee
Forum|alt.badge.img+5
  • Employee
  • 179 replies
  • Answer
  • October 3, 2020

Hi Niclas, a full load should be updating the _I table. The behavior you are describing is not expected and should be sorted out. Have you made any progress here? 


Reply


Cookie policy

We use cookies to enhance and personalize your experience. If you accept you agree to our full cookie policy. Learn more about our cookies.

 
Cookie settings