How can I execute a stored procedure once a load of a table is done. I know it should be possible. I just don't know where I should configure it
Solved
Executing stored procedure
Best answer by JTreadwell
Hi Thire,
This section in the user guide explains how to do this:
https://legacysupport.timextender.com/hc/en-us/articles/360051848111
You would create a script action, then set a pre/post-step on the table.
They you would select your script as a "Post-Step" under "Execute <Table Name> Data Cleansing Rules like so:
+5Hi Thire,
This section in the user guide explains how to do this:
https://legacysupport.timextender.com/hc/en-us/articles/360051848111
You would create a script action, then set a pre/post-step on the table.
They you would select your script as a "Post-Step" under "Execute <Table Name> Data Cleansing Rules like so:
Reply
Most helpful members this week
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
