Hello Guys. I tried to select table from ODX but it deosnt show none (except once query table).
the transfer task work fine (it show succefull) but once I triy to select table in order to send them to the datawerhouse I show nothing.- even if it work fine when I use query tool.
Any suggestion please? thanks
Best answer by pontus.berglund
Hi
A possible reason could be that you have made table selections in either the synchronize or transfer task.
Have you made any selections in the Synchronize task? You can check this by right clicking the data source and click “Select tables...”. If you want to synchronize all tables in the source, you set that here:
You can also make table selections on the transfer task:
Have you made any selections there?
//Pontus
+5Hi
can you please share a screenshots of:
Also please try to close TimeXtender and restart the application to see if the problem persists
Hi
A possible reason could be that you have made table selections in either the synchronize or transfer task.
Have you made any selections in the Synchronize task? You can check this by right clicking the data source and click “Select tables...”. If you want to synchronize all tables in the source, you set that here:
You can also make table selections on the transfer task:
Have you made any selections there?
//Pontus
Hello
Honestly I cant see the select table at data source table
Also in seelct table at task level it show only this:
when *I use query tool it work fine
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
